3dprinters

The department has two Prusa i3 MK3S+.

EduRoam or LU VPN won't cut it. You can use a SSH tunnel if you need to access the printers when off-site.

The printers are controlled using octoprint servers.

Instructions

You can upload gcode through the widget in the left column. When uploaded press the printer symbol and confirm to start.
You replace filament in the same way as before. Make sure you start the correct printer with the correct filament.
If you want to cancel a print through the UI you need an user account. If you don't have one you can pause the print through the UI and restart the printer using the button below the selection knob on the printer. Refresh the octoprint page and wait until it is connected again.
The camera feed is on tab labeled control (IIRC).

The route *.bb.control.lth.se should be resolved by gateway.control.lth.se but is not.

Open administrative shell: Start > type cmd > Right-click and select run as adminstrator)
Run route -p ADD 192.168.187.0 MASK 255.255.255.0 130.235.83.6

Open a terminal.
Find your preferred device using ip link (enp* or eth* for ethernet and wlp* or wifi* for wireless). Replace in code below where it says enpXsY.
Store choosen interface by running DEVICE=enpXsY
Select from following options:

sudo ip route add 192.168.187.0/24 via 130.235.83.6 dev "$DEVICE"

sudo nmcli connection modify "$DEVICE" +ipv4.routes "192.168.187.0/24 130.235.83.6"

Add the following to /etc/netplan/bb.control.lth.se.yaml (needs to be edited with sudo)

network:
  version: 2
  ethernets:
    enpXsY:
      routes:
      - to: 192.168.187.0/24
        via: 130.235.83.6

Then run sudo netplan apply.